I know they're a bit pricey - but having a spare on hand (in the glove
box) is worth while. When they fail, they usually do so suddenly and
without warning. Mine failed while driving home from work one day.
After the $75 tow home, and trying to find one on a (any) store shelf in
the area for two days, I ended up ordering mine too. Now I keep a spare
in the glove box and don't worry about the next time.
My thot -
Michael
Jon wrote:
> Figured out the problem. The problem was the Unilight inside the Mallory distributor. I got one on order. Thanks for the ignition advice. --- In classicmustang@yahoogroups.com, Walt Boeninger <walt@...> wrote:
>
>> It's an ignition problem.
>>
>> Run a wire from the battery to the + side of the coil ... this is side
>> going to the firewall via a harness, not the wire going to the coil.....
>> Try to start it.... if it starts you have a problem in the wiring from
>> the ignition switch through the firewall/harness...
>>
>> Jon wrote:
>>
>>> I'm having a problem getting my 1966 Stang started. Would appreciate any
>>> idea. I've tried everything including jumping up an down. It's my daily
>>> driver. Here's what I did this weekend.
>>> 1. I changed the oil (10W 40) (1969 302 10:1 compression bored 60 over.
>>>
>>> 2. I pulled the valve covers to re-paint them, while they were off I
>>> tightened the rocker arm nuts a 1/4 turn.
>>>
>>> 3. put the new filter on; new oil; valve covers back on and it would
>>> crank but not start. tried it a few more times and no spark. I checked
>>> the plug wires that I didn't knock one loose pulling the valve covers
>>> and nope. I tried to jump the battery off and still the same thing; It
>>> cranked but wouldn't fire. I put the battery on the charger and fully
>>> charged it and the same thing the engine wouldn't fire. I pulled the
>>> starter and sure enough the teeth on the started were ground down
>>> (probably from my too many attempts to crank it). I put a new starter on
>>> and it does the same thing cranks but will not fire. The teeth on the
>>> flywheel looked fine. I shot a little starter fluid in the carb and
>>> still no fire. I replaced and gapped the new spark plugs and still crank
>>> but not fireing up.
>>> I'm at my wits end and can't figure it out. It never sits, and runs
>>> great 10 to 20 miles a day. Could I have messed up by tightening the
>>> rocker arm nuts? I also backed them off a quarter turn and still it
>>> wouldn't fire up. Help
>>> Thanks, Jon
>>>
------------------------------------
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/classicmustang/
<*> Your email settings:
Individual Email | Traditional
<*> To change settings online go to:
http://groups.yahoo.com/group/classicmustang/join
(Yahoo! ID required)
<*> To change settings via email:
mailto:classicmustang-digest@yahoogroups.com
mailto:classicmustang-fullfeatured@yahoogroups.com
<*> To unsubscribe from this group, send an email to:
classicmustang-unsubscribe@yahoogroups.com
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
No comments:
Post a Comment