Re: [SPAM]Re: [Classic Mustang] Dash Trim Panel Removal

Thanks.  Just ordered a set

joe

----- Original Message -----

From: Ronald Cordes

To: classicmustang@yahoogroups.com

Sent: Tuesday, November 11, 2008 4:33 PM

Subject: [SPAM]Re: [Classic Mustang] Dash Trim Panel Removal

http://akamaipix.crutchfield.com/products/2000/180/h180SPK4042p.jpg

 

use this worked awesome for me.

 

Ron

---

From: Joe/Pat Oliver <JoeOliverCA@earthlink.net>
To: classicmustang@yahoogroups.com
Sent: Sunday, November 9, 2008 7:47:04 PM
Subject: [Classic Mustang] Dash Trim Panel Removal

I am removing the dash panel trim.  I have taken out the glove box and radio.  The car is a 68 coupe.  The pieces are held on by hex nuts.  Problem is getting the hex nuts off.  My ratchet doesn't have sufficient room and I cannot see very well without standing on my head.  I have removed the right hand piece but was hard.  Are there any easy ways to remove the hex nuts or special tools that would help.

Any suggestions appreciated.

joe

__._,_.___

Your email settings: Individual Email|Traditional
Change settings via the Web (Yahoo! ID required)
Change settings via email: Switch delivery to Daily Digest | Switch to Fully Featured
Visit Your Group | Yahoo! Groups Terms of Use | Unsubscribe

__,_._,___