Re: [Classic Mustang] fiberglass hood

I'm not familiar with Evercoat, but I do know many of the undercoating products are oil based and don't handle heat well...

I've even seen spray in bedliner products that will melt under high heat conditions.  Makes a REAL mess....

 

PLEASE: STOP E-MAIL HARVESTING
Delete my name and e-mail address before forwarding this e-mail to anyone.
Thank you :-)
Use BCC when sending to multiple addresses.

 

Let's roll...

---

From: carlos calvillo <ccalvillo@sbcglobal.net>
To: classicmustang@yahoogroups.com
Sent: Friday, November 14, 2008 10:51:53 PM
Subject: [Classic Mustang] fiberglass hood

I am preping a fiberglass hood for my 65. I was thinking of spraying
evercoat rubberized undercoating on the bottom of the hood. I am
concerned about the temp rating of the product. The instructions do
not mention the temp rating nor does it say to use in engine
compartment. Has anybody done this or have any knowledge on this?

__._,_.___

Your email settings: Individual Email|Traditional
Change settings via the Web (Yahoo! ID required)
Change settings via email: Switch delivery to Daily Digest | Switch to Fully Featured
Visit Your Group | Yahoo! Groups Terms of Use | Unsubscribe

__,_._,___