When I put in the new wiring harness, I failed to save the connector
from the old turn signal switch. Now I'm having trouble figuring out
which wire goes to which connector on the new wiring harness.
An e-mail to Painless technical support was unanswered, so I am going
to try and call them for assistance.
I know that one of the wires is for the horn, and the others are for
the signals on either side.
Any suggestions? Could I use a multimeter and look for continuity when
the switch is in the left and right positions, and when the horn button
is pushed?
Your help would be greatly appreciated.
Steve
Racine, WI
------------------------------------
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/classicmustang/
<*> Your email settings:
Individual Email | Traditional
<*> To change settings online go to:
http://groups.yahoo.com/group/classicmustang/join
(Yahoo! ID required)
<*> To change settings via email:
mailto:classicmustang-digest@yahoogroups.com
mailto:classicmustang-fullfeatured@yahoogroups.com
<*> To unsubscribe from this group, send an email to:
classicmustang-unsubscribe@yahoogroups.com
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
No comments:
Post a Comment